cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
350
Views
0
Helpful
2
Replies

Interface Vlan configuration

fgasimzade
Level 4
Level 4

I have just assigned a new interface vlan:

interface Vlan208

ip address 192.168.208.18 255.255.255.240

But the problem is when I do

sh ip route 192.168.208.16

I get

% Network not in table

What is the problem?

1 Accepted Solution

Accepted Solutions

satish_zanjurne
Level 4
Level 4

Hi,

1.Check whether vlan interface is Up.Use command "show interface vlan 208"

2.If it is not up, see whether any port is added into vlan 208? If it is not , kindly add a port to vlan 208 and then see "show ip route"

HTH..rate if helpful..

View solution in original post

2 Replies 2

satish_zanjurne
Level 4
Level 4

Hi,

1.Check whether vlan interface is Up.Use command "show interface vlan 208"

2.If it is not up, see whether any port is added into vlan 208? If it is not , kindly add a port to vlan 208 and then see "show ip route"

HTH..rate if helpful..

Oh, right..

I was too drunk yesterday ))

Thank you, my friend

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: