10-12-2008 08:44 PM - edited 03-06-2019 01:53 AM
I have just assigned a new interface vlan:
interface Vlan208
ip address 192.168.208.18 255.255.255.240
But the problem is when I do
sh ip route 192.168.208.16
I get
% Network not in table
What is the problem?
Solved! Go to Solution.
10-12-2008 08:52 PM
Hi,
1.Check whether vlan interface is Up.Use command "show interface vlan 208"
2.If it is not up, see whether any port is added into vlan 208? If it is not , kindly add a port to vlan 208 and then see "show ip route"
HTH..rate if helpful..
10-12-2008 08:52 PM
Hi,
1.Check whether vlan interface is Up.Use command "show interface vlan 208"
2.If it is not up, see whether any port is added into vlan 208? If it is not , kindly add a port to vlan 208 and then see "show ip route"
HTH..rate if helpful..
10-12-2008 08:56 PM
Oh, right..
I was too drunk yesterday ))
Thank you, my friend
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide