10-12-2008 08:44 PM - edited 03-06-2019 01:53 AM
I have just assigned a new interface vlan:
interface Vlan208
ip address 192.168.208.18 255.255.255.240
But the problem is when I do
sh ip route 192.168.208.16
I get
% Network not in table
What is the problem?
Solved! Go to Solution.
10-12-2008 08:52 PM
Hi,
1.Check whether vlan interface is Up.Use command "show interface vlan 208"
2.If it is not up, see whether any port is added into vlan 208? If it is not , kindly add a port to vlan 208 and then see "show ip route"
HTH..rate if helpful..
10-12-2008 08:52 PM
Hi,
1.Check whether vlan interface is Up.Use command "show interface vlan 208"
2.If it is not up, see whether any port is added into vlan 208? If it is not , kindly add a port to vlan 208 and then see "show ip route"
HTH..rate if helpful..
10-12-2008 08:56 PM
Oh, right..
I was too drunk yesterday ))
Thank you, my friend
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: