cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
552
Views
0
Helpful
5
Replies

Installation Error - CUCM release 6.1(2)

sendia.alzaabi
Level 1
Level 1

we started a fresh installation, but it failed giving below error msg:

"The installation has faild and must be restarted to recover from failure. You may dump diagnostic information at this time to a USB storage key. Would you like to dump diagnostic information? "

I already restarted the server[MCS-7816] many times and each time the same error msg appears.

Kindly assist on above at the earliest..

S.Al Zaabi

5 Replies 5

renier.dewitte
Level 1
Level 1

i had the same problem

i just started an new installation and the problem was solved no error.

did you manual restart you server?

Thanks for your reply. yes i already restarted the Server, but no luck. the same error appears again and again.

I've got that problem because is manual restart my server after the installation.

then I started a new installation , installation started , I went home and the next morning I could login to cucm.

actually, this problem occurred during the installation. later i had to restart the server as instructed in the error msg, but with no use!

I have the same issue but with CUCM 7.0(1). How was this issue solved?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: