Qos issue

Unanswered Question
Oct 13th, 2008

Hi guys, just a niggling issue i have. I have auto qos set across the Lan here, but when i do a show policy-map interface, when it lists the all the interfaces it doesnt show as any packets matching? does anyone know why this may occur?

As always any help always appreciated.

Dan

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
allan.thomas Mon, 10/13/2008 - 14:26

This depends on the marking or classification within the service-policy, and whether you have applied it ingress or egress.

Can you please post the config to have a better understanding of exactly has been configured by Auto-Qos.

Rgds

Allan.

Marwan ALshawi Mon, 10/13/2008 - 19:25

ok

the thing is the qos should be cofigured end to end from the access-switch to the edge router

u need tomake sure that u have the right trust boundaries configured correctly

for example trust cos or cisco-phon on access ports and trust dscp on uplinks from switch to switch and from switch to router

this way u will keep ur marking along the way to the edge router

also have a look at the following link which is a case similer to urs i have discussed:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc1b1f6/2#selected_message

good luck

if helpful Rate

Actions

This Discussion