cwwlse-1030-k9 problem

Unanswered Question
Oct 13th, 2008
User Badges:

dear all


i forgot the password of the cwwlse-1030-k9

and i try this below

--------------------------

0: CiscoBre

1: CiscoBreR

--------------------------

press 1

# erase config


when i press 1,it takes a long time but can not come into #


what can i do???


thanks a lot!!!


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
Rob Huffman Mon, 10/13/2008 - 07:08
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Jian,


Here is the whole process (check step # 4);


Recovering from the Loss of All Administrator Passwords

If you cannot log on to the system and perform administrative tasks, perform the following procedure.


Procedure



--------------------------------------------------------------------------------


Step 1 If there is a monitor or keyboard connected to the WLSE, remove it.


Step 2 Connect a console terminal or PC running Hyper Terminal to the WLSE's console/serial port. Use the cable supplied with the WLSE and, if necessary, the DB-9-to-RJ-45 console adapter.




--------------------------------------------------------------------------------


Note Use the serial port; do not use the video port.



--------------------------------------------------------------------------------


For more information on the console/serial port, see the Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine:


•For the CiscoWorks 1130 WLSE, see


http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cwparent/cw_1105/wlse/2_5/inst_gd/ig_inst.htm


•For the CiscoWorks 1130-19 WLSE, see


http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cwparent/cw_1105/wlse/2_9/i_gd/ig_over.htm.


Step 3 Power the system off, then power it back on. Boot messages appear, and then following prompt appears:


-----------------------------------

0: CiscoBre

1: CiscoBreR

-----------------------------------

Step 4 Use the Up Arrow and Down Arrow keys to select 1 for CiscoBreR and press Enter. The following prompt appears:


bash-2.05a#

Step 5 Enter the following command. This erases the WLSE's configuration, returns the WLSE to factory defaults, and reloads the WLSE.


bash-2.05a# erase config

Step 6 After the WLSE starts up, a login prompt appears. Log in as setup, and use the setup program to configure the system. This allows you to add a password for the admin user.



http://www.cisco.com/en/US/docs/wireless/wlse/2.9/user/guide/CLIadmin.html#wp1075616


Hope this helps!

Rob

Actions

This Discussion

 

 

Trending Topics - Security & Network