7906 with CM 4.1(3)sr6a

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)

I opened a case with TAC to figure this out. Solution was that there was a bug in the dev pack. A value in SQL wasn't properly updated. As a warning, mucking with SQL can really screw up your CallManager install, so take the following info with a dose of responsibility.

I performed these steps using query analyzer on the publisher, making sure to select the active CallManager database before executing the queries

Use this query to check the value:

SELECT * FROM TypeProduct WHERE (Name = 'Cisco 7906')

Use this query to update the value to = 1 which means it will be displayed

Update TypeProduct set showInDropDown='1' where enum = '268'

Cisco tech suggested restarting IIS/WWW SVC after making these changes, but that didn't appear to be necessary.


This Discussion