I need to configure a new internet router to install on our perimeter network. I need help in the following:
1. the standards for internet router configurations - some tips
2. the IOS to upgrade to from System image file is "flash:c1841-ipbase-mz.124-3i.bin".
3. The router is a Cisco 1841.
Please see the following show version output for the new router.
Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(3i), RELEASE SO
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Wed 28-Nov-07 18:17 by stshen
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
yourname uptime is 36 minutes
System returned to ROM by power-on
System image file is "flash:c1841-ipbase-mz.124-3i.bin"
Cisco 1841 (revision 7.0) with 114688K/16384K bytes of memory.
Processor board ID FHK1233228R
2 FastEthernet interfaces
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
31360K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
Your ideas will be great.