Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
307
Views
3
Helpful
1
Replies

Problem in VRRP configuration between two VPN Concentrator

massimiliano.serafino
Level 4
Level 4

‎10-14-2008 02:45 AM - edited ‎02-21-2020 03:59 PM

Hi,

I've a problem as specified in Title.

It seems that the configuration is correct, but when I shutdown the master I can't ping to the virtual address..the standby is on and I can manage it....but the virtual address is not responding.

Any ideas?

Thank you.

Best regards.

Massimiliano.

Labels:
0 Helpful
1 Reply 1

ajagadee
Cisco Employee
Cisco Employee

‎10-14-2008 05:14 PM

Hi,

I think this is expected behavior.

Note: VRRP enables redundancy for tunnel connections only. Therefore, if a VRRP failover occurs, the backup only listens to tunnel protocols and traffic. Pinging the VPN Concentrator does not work. Participating VPN Concentrators must have identical configurations. The virtual addresses configured for VRRP must match those configured on the interface addresses of the Master.

Please refer the below URL for details:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_tech_note09186a0080094490.shtml

Regards,

Arul

** Please rate all helpful posts **

Customers Also Viewed These Support Documents