Amit Singh Tue, 10/14/2008 - 04:39
User Badges:
  • Cisco Employee,

I think its not possible with onboard fe interfaces which are l3 only. I havenot tried setting up the l3 etherchanne using the ports though...might be worth trying..


i know its possible with the use of Ether switchmodules on the router.

hipohoneywell Tue, 10/14/2008 - 04:46
User Badges:

When I issue the command "channel-group 1", the router says "channel-group 1 is not configure", which tells that somehow the channel can be configure.

Any help, please

glen.grant Tue, 10/14/2008 - 06:15
User Badges:
  • Purple, 4500 points or more

The command is probably there in case you have installed like hwic switch modules in which you can channel those interfaces .

Actions

This Discussion