cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
480
Views
0
Helpful
6
Replies

Unity 4.2 - Cut Off first greeting

malosse
Level 1
Level 1

Hello

I've the following problem with my unity 4.2.

Each time we connected to Unity to listen our message, we are missing the first word. The system "... elcome to Unity .." instate of "Welcome to Unity ..."

This problem occur only for the first connection to unity.

Any idea about this problem.

6 Replies 6

Brandon Buffin
VIP Alumni
VIP Alumni

Try the following. Go to Unity Tools Depot on the Unity server > Switch Integration Tools > Edit Switch Utility. Click Incoming Calls. Increase the value of "Delay before opening". I believe this change will require a restart of Unity.

Hope this helps. If so, please rate the post.

Brandon

Hello Brandon

I've seen this information in another post, but when i open this tools, i don't have the button "Click incoming calls" ...

Any idea ?

Manu

After opening the Edit Switch Utility, click Edit to edit the configuration. You should then see an "Incoming Calls" tab at the top.

Brandon

Hello Brandon

I haven't edit button on my tools ... :-(

Only "New" and "Quit buttons !

If it help you, this is what i can see on the Cisco0002.ini file:

; $COPYRIGHTSTART ********************************************************

; Copyright © 1998-2001 Cisco Systems, Inc. All rights reserved.

;

; This product is protected by one or more of the following US patents:

; 5,070,526; 5,434,906; 5,488,650; 5,533,102; 5,568,540; 5,581,604;

; 5,625,676; 5,651,054; 5,940,488; 6,041,114. Additional US

; and foreign patents pending.

;

; Unity and ActiveAssistant are trademarks of Cisco Systems, Inc.

;

; Cisco Systems, Inc.

; San Jose, California

; U.S.A.

; $COPYRIGHTEND **********************************************************

[Identity]

SwitchManufacturer=CISCO

SwitchModel=CallManager

SwitchSoftwareVersion=3.0(1) or later

IntegrationType=TAPI

[MWI Default]

MWIType=TAPI

Active=Yes

CodesChangeable=No

Interesting. Are you logged in with the unityinstall account or an account with proper privileges? Is this a Callmanager integration?

Brandon

Hello

I tried to use the tool in UnityAdmin and UnityInstall. Same behavior ...

I look on another file on this server like Siemens or Ericsson and i can look this line on the file:

[configuration]

delayBeforeOpenning=0

...

The section, [configuration], is not présent on "Cisco0002.ini" file

=> it is Callmanager integration.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: