Hi, is there command to debug an Interface on an ASA5510 (7.2) ?
We are experiencing intermittent disconnections on the outside ASA interface which is connected to our ISP's 1841 router.
This is bringing down our remote VPN L2L connections
I have switched the interface to 100mb Full Duplex from auto to match the setting on the 1841 and I'm using a crossover but the issue still occurs with this error in the logs
"Line protocol on Interface Ethernet0/0, changed state to down"
The Interface and VPN then comes back up straight away but all RDP sessions running over our links are disconnected