Configuration E1 R2 Trunks

Unanswered Question
Oct 15th, 2008

Guys,

need help to configure our gateway 2811. I have two (2) E1 ports.

Port: 0/0/0 - to be used for DID

Port: 0/0/1 - to be used for DOD

Can you guide me to configure first my controller then a sample dial-peer I will use to use for incoming and outgoing.

I want to use port: 0/0/0 for DID and port: 0/0/1 for outgoing.

I need your advice and quick action to this issue.

regards.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mike.lo Thu, 10/16/2008 - 02:44

hi, please find below configure is workable in our Manila Branch. I hope this can help you.

!

voice service voip

allow-connections h323 to sip

allow-connections sip to h323

h323

sip

!

!

voice class codec 99

codec preference 1 g711ulaw

codec preference 2 g729br8

!

!

voice translation-rule 1

rule 1 // /5/

!

!voice translation-profile inbound

translate called 1

!

!

controller E1 0/0/0

framing NO-CRC4

ds0-group 0 timeslots 1-15 type r2-digital r2-compelled ani

cas-custom 0

country philippines

dnis-digits min 1 max 3

description TYPE=PRI DEST=xxx BW=2M!

!

voice-port 0/0/0:0

translation-profile incoming inbound

!

!

dial-peer voice 402 voip

description xxx

preference 1

destination-pattern 5...

voice-class codec 99

voice-class h323 1

session target ipv4:

dtmf-relay h245-alphanumeric

ip qos dscp cs5 media

no vad

!

Actions

This Discussion