1841 interface modules

Unanswered Question
Oct 15th, 2008

I am trying to determine which interface module I need to provide a ethernet interface to the 1841. I have a fractional T1 in the one interface, but want to bring in a second network segment from one of my switches. Can someone point me to the correct WIC?

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Wed, 10/15/2008 - 11:16

Hello,

The Cisco 1841 router has two interface card slots. Each slot can accommodate a Cisco WIC, VWIC (data only mode), or a single-wide high-speed WIC (HWIC).

Note Cisco double-wide HWICs are not supported in the Cisco 1841 router.

But I cannot find the list of the allowed modules I would guess NM-1FE2W.

Hope to help

Giuseppe

wpharaon Mon, 11/24/2008 - 05:01

ediortiz,

yes Cisco 1841 doesn't support the double-wide form factor (i.e. HWIC-D-9ESW), it supports 2 Single-wide HWICs!

Actions

This Discussion