AIP SSM w/ Failover

Answered Question
Oct 15th, 2008

Hi all,

I will setup a module AIP SSM with failover active/standby. Did someone do this configuration? The active ASA will replicate the IPS config to the standby ASA? I look for some documentation on cisco site but I not found.


I have this problem too.
0 votes
Correct Answer by abinjola about 8 years 5 days ago

Unlike ASAs..SSM Modules do not replicate there configs to each other..they are treated as separate units have to manually confgure both the Modules


See if this helps !

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading. Thu, 10/16/2008 - 10:56

It`s very bad, because all config that I do in a module a will need to do the same config to each other... =(

But thank you a lot for you answer!!!


This Discussion