NM-2CE1-T1-PRI not working on C2811!!

tarik.fakir · ‎10-16-2008

Hello,

My module is not working under cisco 2811 router. I found the interfaces in the "sh ver" but when I want to use the card (card type e1) this not works

Here bellow sh ver

What should I do to enablethe module

Thanks

##

OTA96#sh ver

Cisco IOS Software, 2800 Software (C2800NM-IPBASE-M), Version 12.4(3i), RELEASE

SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Compiled Wed 28-Nov-07 21:09 by stshen

ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)

OTA96 uptime is 1 minute

System returned to ROM by power-on

System image file is "flash:c2800nm-ipbase-mz.124-3i.bin"

Cisco 2811 (revision 53.50) with 249856K/12288K bytes of memory.

Processor board ID FCZ12237337

2 FastEthernet interfaces

2 Channelized (E1 or T1)/PRI ports

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102

OTA96#card type ?

% Unrecognized command

OTA96#card ?

% Unrecognized command

OTA96#card

##

Sushil Kumar Katre · ‎10-16-2008

Hi,

Please configure the command in the configuration mode -

OTA96(config)#card type E1

http://www.cisco.com/en/US/docs/ios/12_4/interface/configuration/guide/h_et2sw.html#wp1064900

-> Sushil

tarik.fakir · ‎10-16-2008

Hello Sushil,

But the command not working (this is the root of our problem), the command not exists!!

OTA96(config)#car?

carrier-id

OTA96(config)#car

tarik.fakir · ‎10-16-2008

1 more detail

I'm getting this message when the router start up

*Mar 1 00:00:15.391: %ET2_MODULE-3-INITFAILURE: ET2 (slot 1), PCI initialization failed at ../nms/ernest_t2/nms_et2.c - line 1067 arg 0 -Process= "Init", ipl= 3, pid= 3 -Traceback= 0x8115B5DC 0x805AC31C 0x805AC814 0x8028D590 0x8028D700 0x8222B8DC 0x81152DE8 0x811530C8 0x8023C990 0x80240094

Is the module faulty?

B.R

Edison Ortiz · ‎10-16-2008

It looks like a faulty module, I recommend opening a TAC case for further troubleshooting.

HTH,

__

Edison.