Our customer bought 10 Mbps Metro Ethernet services from the SP on a Gigabit Ethernet port and they are running into issues when they try shaping the Gigabit Ethernet port to 10Mbps.
Thanks Edison for your response. I looked at these configuration documents. Actually the Customer is seeing a specific problem where on a 1000 Mbps port he is able to shape to say 100/ 500 Mbps but when he tries to shape that port to very low values like -- 10 Mbps etc that he is running into issues.
I was wondering if there is a lower limit on a Gig pot to what value can it be shaped
Normal 3750 ports only support shaping in tiers (multiples of 6?), although the shape command allows 1% increments. I.e. you can't actually obtain the exact percentage you shape for.
If possible, hard code the port for 10 or 100, and then shape.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
