Change 1130AG LAP network settings remotely

Unanswered Question
Oct 17th, 2008
User Badges:

I have a 1130AG LAP that i upgraded to LWAPP. I chose to keep the static IP of the access point. I suspect that during the upgrade process the access point was not set with the IP address of the WLC.

Is there any way that I can remotely change the access point's network settings? It has to be done remotely because the access point ins in an inaccessible location

Thanks in advance for any help forwarded.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
dennischolmes Fri, 10/17/2008 - 09:22
User Badges:
  • Gold, 750 points or more

Is the AP on the same LAN segment? If it is it should discover the WLC in its LWAPP discovery process. If not, you will need to prime the AP with the controller address.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode