Change 1130AG LAP network settings remotely

rhobab · ‎10-17-2008

I have a 1130AG LAP that i upgraded to LWAPP. I chose to keep the static IP of the access point. I suspect that during the upgrade process the access point was not set with the IP address of the WLC.

Is there any way that I can remotely change the access point's network settings? It has to be done remotely because the access point ins in an inaccessible location

Thanks in advance for any help forwarded.

Victor

dennischolmes · ‎10-17-2008

Is the AP on the same LAN segment? If it is it should discover the WLC in its LWAPP discovery process. If not, you will need to prime the AP with the controller address.