10-17-2008 07:33 PM - edited 03-03-2019 11:58 PM
Hi, can you give your great insight?
Please find attached diagram and 3 basic questions. Thanks!
10-17-2008 07:36 PM
10-17-2008 09:30 PM
Hi,
Since u have used 3750-E image, i recommand to break the layer 2 at 3750-E. And make etherchannel to connect to core switches.
10-18-2008 04:33 PM
Since both the 3750-E and 3750 are multilayer switches, you could route on either, although if you route on the IDF stacks, you'll likely want to stop spanning VLANs across multiple IDFs.
Normally if you enable routing on your MDF stack, you would use a dynamic routing protocol between it and your core routers (although I would select a better oriented IGP rather than iBGP). Or, you can enable routing on the MDF, use a couple of default static routes to MSRP addresses on the 6500s and then make the MDF the HSRP gateway.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide