Read/Get SNMP from Cisco phones

Unanswered Question
Oct 18th, 2008

Is there a way to read/get snmp information from cisco phones? I have snmp enabled on the call manager and subscriber, but can't find a way to read snmp info from the phones. Is that possible? Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
manjithkumar1972 Mon, 07/25/2011 - 02:43

Hi

The following is configuration to be done for getting the SNMP traps for Phones, as per CUCM manual:

Configuring CISCO-CCM-MIB Trap Parameters

Unified CM and Unified CM BE only:

Use these guidelines to configure CISCO-CCM-MIB trap settings on your system:

Set ccmPhoneFailedAlarmInterval (1.3.6.1.4.1. 9.9.156.1.9.2 to a value in the range 30-3600 by using the SNMP Set operation; for example, use the net-snmp set utility to set this OID value from the linux command line using: snmpset -c

-v2c

1.3.6.1.4.1.9.9.156.1.9.2 .0 i

You can also use any other SNMP management application for the SNMP Set operation.

Set ccmPhoneStatusUpdateAlarmInterval (1.3.6.1.4.1.9.9.156.1.9.4) to a value in the range 30-3600 by using the SNMP Set operation; for example, use the net-snmp set utility to set this OID value from the linux command line using:

snmpset -c

-v2c

1.3.6.1.4.1.9.9.156.1.9.4.0 i

You can also use any other SNMP management application for the SNMP Set operation.

But can someone help me in getting the Linux CLI prompt in CUCM, as these commands are to given on Linux CLI, or is there a mistake in my understanding.

Thanks

Actions

This Discussion