10-19-2008 11:11 PM - edited 02-21-2020 03:59 PM
Hi,
Can you tell me where I can find a configuration guide of a site-to-site vpn between two ISRs? Cisco Search displayed me tons of results.
Thanks
10-19-2008 11:19 PM
Here are some links, however it would be better if you would give more details. Topology,dynamic routing requirement, NAT, Internet or WAN? etc.
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008009448f.shtml
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008009463b.shtml
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008014f8ab.shtml
Please rate helpful posts.
Regards
Farrukh
10-19-2008 11:19 PM
Check this out
There is also nice commented configuration
http://www.priscilla.com/ipsecexample.htm
M.
Hope that helps rate if it does
10-19-2008 11:41 PM
I have two Cisco 2811 connected with a WAN link. At the Ethernet side of each router, sits the office LAN.
The priscilla document is appropriate.
Is it possible to configure the site to site VPN with SDM on both routers? are there some limitations? What method do you suggest me to follow: command line or SDM?
10-20-2008 12:53 AM
I prefere Command line , I have configuration under my control ....but it depends on preferences
If you want configure VPN with SDM check this document
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide