10-20-2008 01:42 AM - edited 03-06-2019 02:02 AM
How can I achieve synchronization of the Cat 6500 vlan-group definitions. VTP domain only updates the 'sh vlans'
yet, the 'show firewall vlan-group' does not display the assigned vlans.
Solved! Go to Solution.
10-20-2008 02:29 AM
Unfortunately you can't, you just have to manually assign them on each switch. It is a pain especially as if the 2 switches have inconsistent vlan-group definitions this can break FWSM failover.
Jon
10-20-2008 02:29 AM
Unfortunately you can't, you just have to manually assign them on each switch. It is a pain especially as if the 2 switches have inconsistent vlan-group definitions this can break FWSM failover.
Jon
10-20-2008 02:50 AM
After configuring failover on FWSM, the hostname on the secondary unit gets overwritten. Can this be avoided. I would like to identify via the hostname that which one is active.
Regards.
10-20-2008 10:02 AM
Use Prompt command on primary to recongnize which one is active.
prompt hostname context state
Will add sate (primary/secondary) to the prompt.
Your prompt will show you if you are working on an Active or Standby FWSM
HTH
Syed Iftekhar Ahmed
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: