ASA Mutiple NAT

Unanswered Question
Oct 20th, 2008
User Badges:

Hi everybody i have simple situation,

i have a LAN and its connected to ASA and i have a PAT to the lan , so every one in the LAN is going out with the interface IP.


the problem that i have Mail server in MY LAN )same IP range , and i want it to go out with different public ip address

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
ray_stone Mon, 10/20/2008 - 06:31
User Badges:

In your case, just use static map entry of your Mail Server local IP with Public IP and make access-list for incoming public IP traffic for using mail services.


Ray

motasemkhater Mon, 10/20/2008 - 06:44
User Badges:

i have

static(inside,outside) public ip private ip


this will redirect the traffic that came to public ip to my server ,

what i need that my server to go out with the public ip ..

i think i will need GLOBAL and NAT command ??

suschoud Mon, 10/20/2008 - 06:48
User Badges:
  • Gold, 750 points or more

If you want only your server to xlate to public ip,that is already done through the static command you have.


Go to " whatismyip.com " on the server and you would see the public ip address used in static.


If you have some more computers on inside which need to access internet ( you need to xlate them into public ip ),add :



nat (inside) 1 0 0

global (outside) 1 interface



Do rate if helpful.



Regards,

Sushil

motasemkhater Mon, 10/20/2008 - 10:18
User Badges:

i already have

nat (inside) 1 0 0

global (outside) 1 interface


and all inside PC's and servers including my mail server are going out with the interface public IP ,


i want the mail server (which have an ip address from inside network) to go out with different public IP i determine



Actions

This Discussion