10-20-2008 06:37 AM - edited 03-06-2019 02:02 AM
After configuring failover on FWSM, the hostname on the secondary unit gets overwritten. Can this be avoided. I would like to identify via the hostname that which one is active.
Regards.
Solved! Go to Solution.
10-20-2008 10:32 AM
The code you are running A1(6.3a) doesnt support this command.
Syed Iftekhar Ahmed
10-20-2008 10:01 AM
Use Prompt command on primary to recongnize which one is active.
prompt hostname context state
Will add sate (primary/secondary) to the prompt.
Your prompt will show you if you are working on an Active or Standby FWSM
HTH
Syed Iftekhar Ahmed
10-20-2008 10:06 AM
Hi,
Thanks for that. Could you also please assist me on the recently posted
under application networking.
Regards.
10-20-2008 10:32 AM
The code you are running A1(6.3a) doesnt support this command.
Syed Iftekhar Ahmed
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: