10-20-2008 06:37 AM - edited 03-06-2019 02:02 AM
After configuring failover on FWSM, the hostname on the secondary unit gets overwritten. Can this be avoided. I would like to identify via the hostname that which one is active.
Regards.
Solved! Go to Solution.
10-20-2008 10:32 AM
The code you are running A1(6.3a) doesnt support this command.
Syed Iftekhar Ahmed
10-20-2008 10:01 AM
Use Prompt command on primary to recongnize which one is active.
prompt hostname context state
Will add sate (primary/secondary) to the prompt.
Your prompt will show you if you are working on an Active or Standby FWSM
HTH
Syed Iftekhar Ahmed
10-20-2008 10:06 AM
Hi,
Thanks for that. Could you also please assist me on the recently posted
under application networking.
Regards.
10-20-2008 10:32 AM
The code you are running A1(6.3a) doesnt support this command.
Syed Iftekhar Ahmed
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide