Change of ACE peer hostname

Answered Question
Oct 20th, 2008
User Badges:

I found the following entry in ACE administration guide but it doesn't work


peer hostname xxxxx


This is to set the secondary units' hostname.



Correct Answer by Syed Iftekhar Ahmed about 8 years 6 months ago

Yes with "no peer hostname" command support on code 1.63 you need to put the hostname on standby before FT configuration.


Syed


Correct Answer by Syed Iftekhar Ahmed about 8 years 6 months ago

The code you are running A1(6.3a) doesnt support this command.



Syed Iftekhar Ahmed



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Syed Iftekhar Ahmed Mon, 10/20/2008 - 10:15
User Badges:
  • Blue, 1500 points or more

This command is in newer codes (2.x) only.

What code are you running?


Are you not seeing this command at all or its there but is not working for you?


Syed Iftekhar Ahmed

new_networker Mon, 10/20/2008 - 10:26
User Badges:

I don't see the command at all. Is this command applicable to global config mode.


The 'show version' output is


Cisco Application Control Software (ACSW)

TAC support: http://www.cisco.com/tac

Copyright (c) 2002-2006, Cisco Systems, Inc. All rights reserved.

The copyrights to certain works contained herein are owned by

other third parties and are used and distributed under license.

Some parts of this software are covered under the GNU Public

License. A copy of the license is available at

http://www.gnu.org/licenses/gpl.html.


Software

loader: Version 12.2[121]

system: Version 3.0(0)A1(6.3a) [build 3.0(0)A1(6.3a) adbuild_02:16:25-2008/


02/02_/auto/adbu-rel3/ws/rel_3_0_0_a1_6.3-throttle/REL_3_0_0_A]

system image file: [LCP] disk0:c6ace-t1k9-mz.3.0.0_A1_6_3a.bin

installed license: no feature license is installed

Correct Answer
Syed Iftekhar Ahmed Mon, 10/20/2008 - 10:31
User Badges:
  • Blue, 1500 points or more

The code you are running A1(6.3a) doesnt support this command.



Syed Iftekhar Ahmed



new_networker Mon, 10/20/2008 - 10:35
User Badges:


So, does it mean the only way to change hostname is after removing the FT group and before reinstating it on the standby module.


Correct Answer
Syed Iftekhar Ahmed Mon, 10/20/2008 - 10:41
User Badges:
  • Blue, 1500 points or more

Yes with "no peer hostname" command support on code 1.63 you need to put the hostname on standby before FT configuration.


Syed


Actions

This Discussion