10-20-2008 07:04 AM
I found the following entry in ACE administration guide but it doesn't work
peer hostname xxxxx
This is to set the secondary units' hostname.
Solved! Go to Solution.
10-20-2008 10:31 AM
The code you are running A1(6.3a) doesnt support this command.
Syed Iftekhar Ahmed
10-20-2008 10:41 AM
Yes with "no peer hostname" command support on code 1.63 you need to put the hostname on standby before FT configuration.
Syed
10-20-2008 10:15 AM
This command is in newer codes (2.x) only.
What code are you running?
Are you not seeing this command at all or its there but is not working for you?
Syed Iftekhar Ahmed
10-20-2008 10:26 AM
I don't see the command at all. Is this command applicable to global config mode.
The 'show version' output is
Cisco Application Control Software (ACSW)
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2006, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
other third parties and are used and distributed under license.
Some parts of this software are covered under the GNU Public
License. A copy of the license is available at
http://www.gnu.org/licenses/gpl.html.
Software
loader: Version 12.2[121]
system: Version 3.0(0)A1(6.3a) [build 3.0(0)A1(6.3a) adbuild_02:16:25-2008/
02/02_/auto/adbu-rel3/ws/rel_3_0_0_a1_6.3-throttle/REL_3_0_0_A]
system image file: [LCP] disk0:c6ace-t1k9-mz.3.0.0_A1_6_3a.bin
installed license: no feature license is installed
10-20-2008 10:31 AM
The code you are running A1(6.3a) doesnt support this command.
Syed Iftekhar Ahmed
10-20-2008 10:35 AM
So, does it mean the only way to change hostname is after removing the FT group and before reinstating it on the standby module.
10-20-2008 10:41 AM
Yes with "no peer hostname" command support on code 1.63 you need to put the hostname on standby before FT configuration.
Syed
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: