WCCP and Multicast

Unanswered Question
Oct 20th, 2008

We have Juniper WX for compressing the traffice between different location. Currenlty it is in-line position. We would like to set it up "off-path" , which will be connected to 6509 IOS switch. We need to enable the wccp and muticast in the switch. Here is portion of switch configure:


interface GigabitEthernet5/1

description Connection to Core_RTR-Gi5/1

ip address 192.168.210.49 255.255.255.252

!

interface Vlan2

description Corporate Segment

ip address 192.168.31.252 255.255.255.0

standby 2 ip 192.168.31.254

standby 2 priority 105

standby 2 preempt


The port 5/1 in the switch will be connected to edge WAN router and the Juniper will be connected VLan 2.


How we configure wccp v2 and muticast in 6909 switch? Please help


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Mon, 10/20/2008 - 11:51

Hello Ken,


1) multicast


conf t

ip multicast-routing


int g5/1

ip pim sparse-dense-mode


int vlan2

ip pim sparse-dense-mode


2) WCCP


http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/wccp.html


The following example shows a general WCCPv2 configuration session:


Router# configure terminal


Router(config)# ip wccp web-cache group-address 224.1.1.100 password alaska1


Router(config)# interface vlan 2


Router(config-if)# ip wccp web-cache redirect out


Note: this may fit or not in your scenario use the doc to understand


Hope to help

Giuseppe


Actions

This Discussion