10-20-2008 09:29 PM - edited 07-03-2021 04:39 PM
We had an Aironet 1300 series and it only operates as an access point even do the location of this device is outdoor.Can anybody help me to configure this device as a bridge so that we can use its full functionality and capability.And if it is posible pls send me the configuration.
thanks alot.
10-21-2008 07:30 AM
A 1300 series bridge runs a very similar version of code that exists on access points, which allows the device to be configured as either a bridge or an access point.
Look at your configuration under "Dot11Radio0". You should see a command along the lines of "station-role XXXXX", where XXXXX can be either access point or root bridge modes. Make sure this says "station-role root bridge". The other end should be configured as "station-role non-root bridge".
Also, under your SSID, ensure that the "infrastructure-mode" command is used.
If you can attach your configuration, we could assist you further.
10-24-2008 10:43 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: