Sip Phones questions

Unanswered Question
Oct 20th, 2008
User Badges:

Hello People,

I am after some information regarding Sip phones with Call manager V6.1. I have had no experience with sip phones only cisco SCCP phones. I would like to know if I would require and additional software /hardware to run sip phones with my current call manager system?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
bwilmoth Fri, 10/24/2008 - 10:24
User Badges:
  • Silver, 250 points or more

I think there is no additional requirement needed to run SIP phone with your call manager version6.1 instead your network should have the following requirements:

• Working Voice-over-IP (VoIP) Network

- VoIP configured on your Cisco routers and gateways

- Cisco Unified Communications Manager Release 3.3(5) or higher installed in your network and configured to handle call processing

The minimum firmware release that must be installed on the phone is 7.2(1).

IP network that supports DHCP or manual assignment of IP address, gateway, and subnet mask


This Discussion