cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
488
Views
0
Helpful
1
Replies

FXO/FXS on MGCP

mehr.cco1
Level 1
Level 1

how to configure FXO/FXS on callmager6?

fro example cptone command is necessary on router or not?

1 Reply 1

allan.thomas
Level 8
Level 8

With MGCP controlled endpoints it is not necessary to configure the cptone command under the voice-port this is done automatically when the configuration is downloaded from CallManager.

Please refer to the following document link for adding a Cisco IOS MGCP Gateway, after step 9 it also details adding FXS or FXO ports to an MGCP gateway :-

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/6_0_1/ccmcfg/b06gtway.html#wp1311169

Hope this helps...

Rgds

Allan.

Pls rate helpful posts..

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: