10-21-2008 08:50 AM - edited 07-03-2021 04:39 PM
Hi,
Apologies if this is posted in the wrong discussion/forum thread.
I have a Aironet 1242AG Wireless Access Point configured in Workgroup Bridge mode. The Access Point associates successfully using WPA-PSK to the existing SSID that we have here. I am able to ping the Access Point's IP address (BVI1) consistently.
However, anything I connect to the FastEthernet port on the Access Point is not accessible from the main network (across the wireless workgroup bridge). I can consistently ping the Ethernet attached device from the CLI on the Access Point itself, but from anything else I get intermittent responses - sometimes nothing at all.
Interestingly, if I either enable or disable infrastructure-client on the Dot11Radio0 interface I get a brief burst of traffic (I'm running a continuous ICMP ping) then it goes dead again.
My intuition says something to do with ARP, but I've tried a number of ARP-related configurations and had no joy.
Can anyone shed any light on this?
TIA,
Regards,
10-23-2008 06:02 AM
No ideas?
10-31-2008 02:15 AM
Hi,
If my memory serves me right, for workgroup bridges you will need to add in the MAC address for each Ethernet device in MAC control list so these can pass traffic through the bridge.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide