Edison Ortiz Tue, 10/21/2008 - 10:12

You need to copy the IOS image in the standy Supervisor as well.


HTH,


__


Edison.

Juan Ignacio Giraldo Tue, 10/21/2008 - 15:32

But the router was operating normally(since 2 months ago), it was not turned off, the IOS has not been changed, nor the register....what can produce such event log ?

Edison Ortiz Wed, 10/22/2008 - 05:22

Perhaps someone deleted the file by accident.


Verify the file is there, if it isn't - please copy it from the active Supervisor to the standby.


HTH,


__


Edison.

Juan Ignacio Giraldo Wed, 10/22/2008 - 06:11

Hello Edison. Thanks for your responses.

Could you please give me a procedure to follow (including commands) so i can verify if the file exists or not and if not, how to copy ?

I'm just a begginer in my job and my boss asked me to perform this taks (to find out how to do that).


Thanks a lot

Juan Ignacio Giraldo Wed, 10/22/2008 - 14:06

Eduard. Hi again.


This is the equipment's sh ver print:



System image file is "bootdisk:c7600s72033-advipservicesk9-mz.122-33.SRB2.bin"


cisco CISCO7606 (R7000) processor (revision 1.0) with 458720K/65536K bytes of me mory.

Processor board ID FOX084000FG

SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache

Last reset from s/w reset

23 Virtual Ethernet interfaces

52 Gigabit Ethernet interfaces

1917K bytes of non-volatile configuration memory.

8192K bytes of packet buffer memory.


65536K bytes of Flash internal SIMM (Sector size 512K).

Configuration register is 0x2102


I don't really understand how can i copy files from one memory to other.


How can i know how many slots for memory my router has ?



Actions

This Discussion