Cannot dial : area code getting stripped off when dialing out

Unanswered Question
Oct 21st, 2008
User Badges:
  • Silver, 250 points or more

Hi,


I am seeing following debugs on gateway router . Why i am seeing in logs "5606751" when i am dialing 830560751? How will i know which DP it is actually using to dial out from debugs?


Oct 21 18:11:34: ISDN Se1/0/0:23 Q931: TX -> SETUP pd = 8 callref = 0x6CC6

Bearer Capability i = 0x8090A2

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98397

Exclusive, Channel 23

Calling Party Number i = 0x2181, '50100'

Plan:ISDN, Type:National

Called Party Number i = 0xA1, '5606751'

Plan:ISDN, Type:National

Oct 21 18:11:34: //392762/80546BB06672/H323/cch323_do_call_proceeding: gw_id=1

Oct 21 18:11:34: //392762/80546BB06672/H323/cch323_do_call_proceeding: set_mode NOT called yet...saved deferred CALL_PROC

Oct 21 18:11:34: //392762/80546BB06672/H323/cch323_send_event_to_h245_connection_sm: Changing to new event H245_LISTEN_REQ_EVENT

Oct 21 18:11:34: //392762/80546BB06672/H323/cch323_h245_connection_sm: state=0, event=0, ccb=64DB31DC, listen state=0

Oct 21 18:11:34: //392762/80546BB06672/H323/cch323_h245_connection_sm: H245_LISTEN: Received event H245_LISTEN_REQ_EVENT while at H245_NONE state

Oct 21 18:11:34: //392762/80546BB06672/H323/cch323_h245_set_new_state: Changing from H245_NONE state to H245_WAITING state

Oct 21 18:11:34: //392762/80546BB06672/H323/cch323_process_set_mode: Setting inbound leg mode flags to 0x10F, flow-mode to FLOW_THROUGH

Oct 21 18:11:34: //392762/80546BB06672/H323/cch323_process_set_mode: Sending deferred CALL_PROC



Thanks in advance.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Chris Deren Tue, 10/21/2008 - 15:40
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

Run "debug voice dialpeer"


Chris

Jaime Valencia Tue, 10/21/2008 - 18:48
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

most probably you have your dial-peer with the 1st digits as exact match and they got stripped. that's working as designed, you need to configure how many digits you want to send if not doing it with the digits on the destination-pattern.


i'd recommend you to go thru the dial-peer configuration guides to get some more insight but let's put it this way


if i have


dial-peer voice 1 pots

destination pattern 123.......


and i dial 1234567890 i will only send NON-EXACT matches = 4567890


HTH


java


if this helps, please rate

Actions

This Discussion