PGW howto suppress hop-count for ISUPV3

Unanswered Question
Oct 22nd, 2008

i have tried to add the hopon property to the trunk-group profile but this property seems to be only available for ANSI-SS7 and not ITU. how else can i suppress this property which is being sent out in the IAM message after arriving from SIP?

Leon

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
hadbou Thu, 10/30/2008 - 12:18

Hopon seems to be only available for ANSI-SS7 and not ITU as you have mentioned. When configuring a profile, you can attach a profile to a signaling service, but both the profile and the signaling service must belong to the same variant. However, you can create a profile even though the signaling service does not exist. While configuring the profile disable the hopon feature which will suppress this property.

A profile allows one or more properties to be set once and then reused multiple times. To create a profile, use the PROV-ADD command as follows:

mml> prov-add:profile:name="profile1",type="grprofile",hopon="0"defaultBC="3_1_KHZ",

confusion="1"

Actions

This Discussion