sh run config example for SIP TRUNK form UC500

Unanswered Question
Oct 22nd, 2008
User Badges:

I hope any of you can help me.

I know that UC500's GUI has the option to configure SIP trunks via its GUI.

I have been trying to configure a TRUNK SIP with CME 4.3, I was provided with:


password: pass1

Outbound proxy (IP address): (e.g.)

For some reason I can not register in proxy server. I do not what I'm doing wrong, I have test many combination without success.

If any of you can try with UC500's GUI to configure SIP trunk using the info I showed (user,pass,domain,proxy IP) and then send me the "sh run file" I will appreciate a lot.

My main doubt is in the options

-voice service voip (all that must include)

-sip-ua (all options)

-dial-peer ( I know GUI does not provide this info)


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion