Configure idle timeout and session timeout in a group-policy.

Answered Question
Oct 24th, 2008
User Badges:

I want that a L2L tunnel be established during a period of time, this tunnel is established in a PIX 515E.

Then i had saw that we must configure the idle timeout in the group-policy, but i dont't know the difference between configuring the idle timout and the session timeout.

Anyone knows what is the difference between this two line commands.

Thanks

Correct Answer by ajagadee about 8 years 7 months ago

Hi,


Session-Timout: At the end of this period of time, the security appliance terminates the connection.

Idle-timeout: If there is no communication activity on the connection in this period, the security appliance terminates the connection.


Please refer the below URL for additional details.


http://www.cisco.com/en/US/docs/security/asa/asa70/command/reference/tz.html#wp1281883


http://www.cisco.com/en/US/docs/security/asa/asa70/configuration/guide/vpngrp.html


Regards,

Arul


*Pls rate if it helps*

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
ajagadee Fri, 10/24/2008 - 06:33
User Badges:
  • Cisco Employee,

Hi,


Session-Timout: At the end of this period of time, the security appliance terminates the connection.

Idle-timeout: If there is no communication activity on the connection in this period, the security appliance terminates the connection.


Please refer the below URL for additional details.


http://www.cisco.com/en/US/docs/security/asa/asa70/command/reference/tz.html#wp1281883


http://www.cisco.com/en/US/docs/security/asa/asa70/configuration/guide/vpngrp.html


Regards,

Arul


*Pls rate if it helps*

Actions

This Discussion