10-24-2008 02:17 PM - edited 07-03-2021 04:41 PM
Hi,
I can't reach one of the controllers on the wism after a downgrade..
controller erases its configuration everytime I reset the module, and i start to configure it again and when i finish, it saves and reboots the controller.. when i check at the 7600's CLI (sh wism module 3 controller 2 status) I've seen the configuratin i've made but "Operational Status of the Controller" is stacked at Keepalive, and I cant reach it. After I reboot the module and check it, all configuration is gone and Operational Status of the Controller:Oper-Up so when i connect the controller configuration wizard comes again..
dc#sh wism module 3 controller 2 status
WiSM Controller 2 in Slot 3 configured with auto-lag
Operational Status of the Controller : Oper-Up
Service VLAN : 200
Service Port : 10
Service Port Mac Address : 0016.464b.3082
Service IP Address : 10.10.10.3
Management IP Address : 169.254.1.1
Software Version : 4.2.130.0
Port Channel Number : 406
Allowed-vlan list : 13-17,250
Native VLAN ID : 250
WCP Keep Alive Missed : 0
Operational Status of the Controller : Oper-Up
Service VLAN : 200
Service Port : 9
Service Port Mac Address : 0016.464b.0882
Service IP Address : 10.10.10.4
Management IP Address : 192.168.40.2
Software Version : 5.1.151.0
Port Channel Number : 405
Allowed-vlan list : 13-17,250
Native VLAN ID : 250
WCP Keep Alive Missed : 0
10-26-2008 07:20 AM
Press ESC when the wlc is in the boot process and see what image the wlc is booting from. Also it looks like your management interface is set for dhcp and is not getting an IP address... since it is getting 169.254.1.1.
10-26-2008 07:52 AM
I think you got it Scott. If the management interface is dhcp and the 6500 is configured for a static address in the same network as the 2nd controller. I would assume he has a vlan set up for management of his wireless. The controller is never completely configured when the reboot occurs because it can't get a valid IP address from the management vlan. It thinks it has failed the setup wizard and reboots with the setup config. Just a theoretical thought process as I don't know this for sure.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: