ASA Failover unit (Failed)

Unanswered Question
Oct 25th, 2008

Hi,

Is there any entry to refresh/re-enforce the failover configuration in case the secondary unit fails and the interfaces go into 'Normal(Waiting)' state.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
new_networker Sat, 10/25/2008 - 07:34

When I try 'failover' command on standby unit, the refresh happens.

FWSM/actNoFailover(config)# failover

FWSM/act(config)#

Detected an Active mate

Beginning configuration replication from mate.

Access Rules Download Complete: Memory Utilization: < 1%

End configuration replication from mate.

But I haven't been able to find any documentation on this. Is 'failover' the right command.

Actions

This Discussion