Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
381
Views
0
Helpful
3
Replies

ASA Failover unit (Failed)

new_networker
Level 1
Level 1

‎10-25-2008 07:24 AM - edited ‎03-11-2019 07:02 AM

Hi,

Is there any entry to refresh/re-enforce the failover configuration in case the secondary unit fails and the interfaces go into 'Normal(Waiting)' state.

Labels:
0 Helpful
3 Replies 3

new_networker
Level 1
Level 1

‎10-25-2008 07:34 AM

When I try 'failover' command on standby unit, the refresh happens.

FWSM/actNoFailover(config)# failover

FWSM/act(config)#

Detected an Active mate

Beginning configuration replication from mate.

Access Rules Download Complete: Memory Utilization: < 1%

End configuration replication from mate.

But I haven't been able to find any documentation on this. Is 'failover' the right command.

0 Helpful

SOL10
Level 1
Level 1
In response to new_networker

‎10-27-2008 07:22 AM

hi

try sh failover state

0 Helpful

srue
Level 7
Level 7
In response to SOL10

‎10-27-2008 09:47 AM

write standby

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card