10-25-2008 07:24 AM - edited 03-11-2019 07:02 AM
Hi,
Is there any entry to refresh/re-enforce the failover configuration in case the secondary unit fails and the interfaces go into 'Normal(Waiting)' state.
10-25-2008 07:34 AM
When I try 'failover' command on standby unit, the refresh happens.
FWSM/actNoFailover(config)# failover
FWSM/act(config)#
Detected an Active mate
Beginning configuration replication from mate.
Access Rules Download Complete: Memory Utilization: < 1%
End configuration replication from mate.
But I haven't been able to find any documentation on this. Is 'failover' the right command.
10-27-2008 07:22 AM
hi
try sh failover state
10-27-2008 09:47 AM
write standby
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: