SFT Switch Fault Tolerance Design

Unanswered Question
Oct 25th, 2008

Hi

Our organization is asked to deploy a SFT design based on 6509 switches .

Cna some one share the configuration for switches on the basis of best practises followed by cisco

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
stephen.stack Sun, 10/26/2008 - 02:02

Hi,

Unfortunatly, there is no one design or config that can be outlined for you. A lot of questions need to asked about your current environment and future growth etc..

A good place to start in terms of desigin is here http://www.cisco.com/en/US/netsol/ns656/networking_solutions_design_guidances_list.html.

After you have read some of these, you may then have some more specific questions about config.

HTH

Stephen

Actions

This Discussion