10-26-2008 10:24 PM - edited 03-15-2019 02:10 PM
hello friends,
i want to configure ISDN BRI ip telephony. .
but i dont know how to configure isdn parameters.plz help me in this.
i am using WIC 1B S/T-V3 card using .will it support for normal ip telephony..if u have any model con fig send me..
i am having doubt that we need use vic card...
thanks
10-27-2008 05:38 AM
Hi
The data WIC you have will not support Voice.
The correct card for voice applications is VIC2-2BRI-NT/TE.
Regards
Aaron
Please rate helpful posts!!
10-27-2008 07:28 AM
thank u
so if we use WIC 1B S/T-V3 the ip telephony will not work.so we use only vic cards
send some example config for isdn
thanks
11-03-2008 03:55 AM
the vic cards will vary for each country or we can use any vic card for bri voice...my country is UAE..
reply me
thanks
11-18-2008 01:25 AM
hi friends thank u all for ur reply....
i configured a isdn bri line using vic2-2bri-nt/te.
i configured every thing.but i am able to call lanaline numbers but i am not able to call mobile and international.i didnt block 0 and 00.and i checked with isp they also saying not blocked....
so any reason is there behind this
like vic card or any commands in isdn bri..
because first time i am configuring isdn bri for voice
thanks
cyril
01-24-2009 03:02 AM
Hello,
I am also configuring CCME using VIC2-2Bri-nt/te, so could you please send me complete configuration. I am unable to call any PSTN no...so help me..
Thanks in advance.
01-24-2009 03:44 AM
if anyone having E1 configuration in Saudi Arabia please share.....
01-24-2009 05:34 AM
Sharma: search the forum, there are numerous examples.
Eldho: Ditto, or open a new thread.
02-02-2009 05:43 AM
Hello Ditto,
I am setting up VOIP call between 2 2801 router using DSL as Primary link and ISDN as secondary link.My calls thrugh the DSL if fine and no issue.I face issue in the below situations.
1-When it fallback to the ISDN the active calls disconnects and it becomes UNIDIRECTIONAL.If I initiate new call that works fine i.e. Bidirectional.
Do you have any solution for this ?
2-Setting up a VPN tunnel between ISDN and DSL will ressolve issue ?
3-I am also unable to dial the PSTN no., it gives reorder tone if I try to access line using either "0" or "9".
Kindly help.
Thanks in advance.
Vijay
02-02-2009 08:17 AM
Hi, as mentioned above you should open a new thread for a different questions.
Also note, in english, "ditto" means "same as above".
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide