IPS 6.1, Inline VLAN Pairs

Unanswered Question

Hi.


Haven't touched a IPS in a while... Trying to configure VLANs 200 and 201 with IPS doing inline VLAN pair inspection. Configured switchport to gig0/0 on IPS as a trunk


switchport mode trunk

switchport trunk encap dot1q


Switch is 3524XL.


Configured a VLAN pair on IPS and assigned them to virtual sensor, but they will not pass traffic. When I use inline interface pairs instead, works fine. Any ideas???


BTW, on the trunk port I do a "show int fa0/11 switchport" and do notice the port in "Self Loopback: Yes". Not sure if this is normal in this type of install.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion