was wondering if its poss to configure a 2610 router as my permiter router (and my default GW) with the BT adsl wireless router as the edge router.
so the set up i would like to have is:
e0 - 192.168.20.1/24 -> port f0/1 on switch - VLAN1
f0 192.168.20.2/24 -> port f0/2 on switch VLAN1
Cisco 2610 router (only 1 physical interface)
f0.1 172.16.1.1/24 VLAN 2
HOST -> port f0/3 on switch VLAN 2 - 172.16.1.2/24 GW 172.16.1.1
there will be a default route on router 0.0.0.0. 0.0.0.0 192.168.20.1
Is this setup poss?? also, am i right in saying that there should be NAT statements on the 2610 router?