X25 protocol translation question

Unanswered Question
Oct 29th, 2008
User Badges:

Hi, I have a legacy X25 host that talks to an IP based system, they are both connected to a router which performs protocol translation from X25 to TCP.

If I disconnect the Ethernet interface (which connects to the IP system), I'd expect to see the X25 call dropped immediately, but it doesn't. It takes about 20 seconds to time out.

Can anyone tell me if this is the default behaviour, or is there anything I can do to speed up the rate at which the call drops as it causes problems on the X25 host if the call doesn;t drop immediately

Many Thanks in advance

Dom

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 1 (1 ratings)
Loading.

Actions

This Discussion