2511 Terminal server

Unanswered Question
Oct 29th, 2008

I'm trying to setup a 2511 as a terminal server. I've connected the ethernet port to the console port of the device I need remote access to. Followed all the steps on this page http://www.cisco.com/en/US/tech/tk801/tk36/technologies_configuration_example09186a008014f8e7.shtml#cs

I've given the loopback a non routable IP ( and used the same to define my IP host

ip host router 2008

but when I telnet from the 2511 using the command telnet 2008 it telnets to the 2511 itself and hangs!!! what am I doing wrong?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Richard Burts Wed, 10/29/2008 - 13:22


You have posted this same question in the Remote Access forum, where I have posted a response. I suggest that any further discussion be consolidated in the Remote Access forum.




This Discussion