Problems w/ ASR 1002 & SPA 10GE cards

Unanswered Question
Oct 29th, 2008

The 10GE SPA interface cards have two LEDs, one for status and the other for link. Both are illuminated, but there is no fiber connected to the cards and I cannot figure out if the whole ASR is bad, or just the cards. Also, the ASR's "boot" LED is constantly blinking, so I'm thinking *something* is messed up with this boat anchor. Any ideas on what to test or look for?

Out of curiosity, is there any way to session into the ESP-10 that's installed like you would with a line card on a 6500? I didn't see anything indicating you actually move from card to card like that with the ASR series.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
deangeloj Fri, 10/31/2008 - 08:38

Nice. Turns out the SPAs are LR and the Nexus 5020 the ASR trunks to is all SR.


This Discussion