The 10GE SPA interface cards have two LEDs, one for status and the other for link. Both are illuminated, but there is no fiber connected to the cards and I cannot figure out if the whole ASR is bad, or just the cards. Also, the ASR's "boot" LED is constantly blinking, so I'm thinking *something* is messed up with this boat anchor. Any ideas on what to test or look for?
Out of curiosity, is there any way to session into the ESP-10 that's installed like you would with a line card on a 6500? I didn't see anything indicating you actually move from card to card like that with the ASR series.